Ran my 3/8 roughing end mill at 1800 RPM then tried 650 and the chips finally looked right | CNC Operators - Freelance Forum - The Community for Independent Professionals
Ran my 3/8 roughing end mill at 1800 RPM then tried 650 and the chips finally looked right
Been fighting chatter and bad finish on a 1018 steel bracket job for two weeks and couldn't figure out what I was doing wrong. Last Thursday I backed the spindle way down to 650 on the same 3/8 rougher and suddenly the chips came off blue and curled instead of that smeared dust look. Same feed per tooth, same coolant, nothing else changed except speed, and the finish came out clean with no squeal. My old shop pushed high RPM for everything and I just never questioned it. Anyone else run roughers that slow on mild steel, or am I leaving too much on the table?