That moment when I realized I was believing a hoax about 9/11 for 15 years

I was watching a documentary at 3 AM last winter and the narrator casually mentioned the collapse sequence matched a controlled demolition video from 1972, and it hit me like a pipe wrench that I'd been cherry-picking my facts based on what felt right instead of what actually held up under basic physics.

Update: That homeowner who refused to let me cut the door jambs flush

She watched me like a hawk the whole time, then after 3 hours told me I was doing it wrong because her brother-in-law said to leave a gap for expansion, but the door wouldn't even close - has anyone else dealt with someone who thinks they know more but won't listen?

Motorized overhead lifts: Ace Garage Storage or Fleximounts?

I'm comparing Ace Garage Storage and Fleximounts for a motorized overhead rack. I plan on doing the assembly myself this weekend. Which one has better motors and build quality?

My art teacher insisted I stick to one style, but switching to pixel art after 6 months is what finally got me a freelance gig.

Shoutout to the guy who told me to use a zip tie for a stuck sensor in a Denver attic last summer

I was about to cut the whole wire run after fighting a jammed PIR for an hour, but looping a small zip tie through the release slot and pulling sideways popped it right off the bracket without breaking anything.

My buddy in the shop said my feed rates were too slow for aluminum

He watched me run a part and told me I could push it way harder, like 200 ipm on the finish pass. I tried it on a test piece and the finish looked way better, no chatter. How do you figure out the right speed for different metals?

Just read that 46% of freelancers don't set aside money for taxes. Found that in a survey from a finance blog.

Had a total lightbulb moment at a trade show in Denver about payment terms.

I was chatting with another contractor who said he puts 'payment due upon receipt' on every single invoice, no exceptions. He explained that it sets clear expectations from the start and cuts down on the 'I'll pay you next cycle' excuses. Has anyone else tried this and seen faster payments?

Spent $300 on a digital fabric printer and it's the best mistake I ever made.

I bought a basic Epson EcoTank and some special inks to try printing my own patterns at home. The first few yards were a mess, with colors bleeding and the fabric feeling stiff. After a lot of trial and error, I got the settings right for a cotton-linen blend, and now I can test a design for about $15 in materials instead of ordering a huge minimum. Has anyone else had a rough start with home fabric printing that actually paid off?

My coworker said his electric bill dropped by $40 a month after he got a smart thermostat, and it made me realize how much energy we waste without even thinking about it.