TIL most guys I see setting up on a slope skip the level check on the outriggers | Crane Operators - Freelance Forum - The Community for Independent Professionals
TIL most guys I see setting up on a slope skip the level check on the outriggers
I was on a job in Fresno last week watching another operator set his pads on a 4 degree grade and he never pulled out a level once, just eyeballed it and started booming up. I checked mine with a torpedo level at each corner because my old trainer drilled it into me, and two of his pads were sitting about an inch off the ground on the downhill side. How many of you actually check every outrigger with a level, or is eyeballing it pretty common on smaller picks?
4 degrees doesn't sound like much until you figure the boom is at 60 feet and that 1 inch gap turns into real load on two pads instead of four. What did his pads look like after he boomed up, did the downhill side dig in or did the ground hold? I'm asking because eyeballing can look fine from the seat when you can't see the gap under the pad from that angle. The part that gets me is he watched you pull a level out and still didn't walk over and check his own. Did he say anything about it or just wave it off like it's a small pick so it doesn't matter?