Hot take: I finally gave up on paper tape and switched to mesh, and I'm still surprised | Drywall Installers - Freelance Forum - The Community for Independent Professionals
Hot take: I finally gave up on paper tape and switched to mesh, and I'm still surprised
For years I was a paper tape guy, no question. I learned on it, my first foreman in Grand Rapids said mesh was for hacks, and I just never questioned it. Then last month I had a basement job in Kalamazoo with 14 outside corners and about 60 feet of tight butt joints, and my paper kept bubbling on me every single coat. I was losing maybe an hour a day chasing blisters. A guy I sub with handed me a roll of mesh and said just try it on the butts, so I did, and honestly the joints came out flatter than my paper work. The mesh hugs the corner and doesn't lift when it dries, which saved me a whole sanding pass. Now I'm not saying paper is dead, because on long flats I still like the strength, but I was wrong about mesh being cheap garbage. Your mileage may vary depending on your mud mix, but has anyone else switched sides like this, and did you go back?
Switched to mesh on one job and now paper is dead to you? Sounds like you just had a bad batch of mud or let it sit too long on those butts. Plenty of guys chase blisters because the mix is too thin or the room's too hot, not because paper is the problem. Try drying conditions and timing before you toss a whole method.